Initially, the Drone is Assembled, then the BLDC motors are integrated to the frame and all the terminals of the power distribution board , ESC and BLDC motors, VTX, Camera, Receiver are soldered properly to maintain the power flow.

Then the Speedybee flight controller is integrated to the frame and also the GPS, power source, camera, VTX , receiver and ESC connected to BLDC, FPV Goggles motors are connected to the flight controller.

After that, the propellers are tightened to the BLDC motor, the battery is connected and connected the flight controller to the Speedybee software based laptop to calibrate the camera, VTX, receiver, GPS, FPV Goggles and using a RC controller, tested out if the drone is properly calibrated and is flying.